SIOEN S2100 WELD SCREEN

300cm Roll Width

50m Roll Length

480 GSM

3 Year Minimum Warranty

View on trade portal

Request a sample

Open a Trade Account

Sioen S2100 is a Silicone coated Glass fibre with an extreme temperature range from -50°C to +180°C.

Sioen S2100 is non-combustible making it ideal for welding screens and welding blankets, It can also be used as a machinery or ducting cover where high heat is a factor.

WIDTH: 300cm
ROLL LENGTH: 50m
NOMINAL WEIGHT: 480gsm
BASE FABRIC: Glass 1360 Decitex
COATING: Silicone
TEAR STRENGTH WARP/WEFT: 180 / 180 N
TENSILE STRENGTH WARP/WEFT: 4500 / 2800 N/5cm
ADHESION: 60 N/5cm
U/V WARRANTY: 3 year minimum
FIRE RETARDANT: AS/NZS 1530.2 / M2
TEMPERATURE RANGE: -50° / +180° C
FABRICATION METHODS: Sewing

These instructions will maintain the appearance and extend the functional life of the fabric.
• PVC Coated Fabrics
• Polypropylene Woven Coated Fabrics
• PVC Coated Nylon/Polyester Fabrics

PVC Coated Nylon/Polyester Fabrics
Care instructions relate to PVC coated side only of fabrics with PVC one.

PROHIBITIONS/WARNINGS
• Do not use solvents, abrasives or harsh detergents to clean
• Do not dry clean
• Do not iron

GENERAL CARE INSTRUCTION
A regular wipe over with warm soapy water followed by rinsing with
cold water will remove normal soiling. Where a build-up has occurred,
the surface should be cleaned with a soft brush and mild, non abrasive
detergent, then rinsed thoroughly.

SPOT CLEANING/SPECIAL TREATMENTS
Mildew may be removed by wiping with a cold solution of household
chlorine bleach having 4% chlorine, in the proportion of one part in
four to water. Rinse thoroughly with cold water.

The customer must inspect the goods upon delivery and report any defects, shortages, damage, or mismatches within 10 days. The company must be given a reasonable chance to inspect any allegedly defective goods. If no notice is given within the timeframe, the goods are considered accepted and free from defects. If the company agrees the goods are defective, it may choose to repair or replace them.

Returns are only accepted if the company approves them in writing, the goods are returned within 7 days at the customer’s expense, and the goods are unused, properly stored, and returned in near-new condition with original packaging and materials.

The company will not accept returns for customised goods, cut textile products, altered or tampered goods, indent goods, or goods that were improperly stored or handled by the customer.

The company may charge a handling fee of 20% of the returned goods’ value (or $100 minimum) and/or return freight costs if the return is due to the customer’s fault or omission.