GENCLEAR F/R

150cm Roll Width

40m / 30m / 20m Roll Length

650 / 900 / 1290 GSM

View on trade portal

Request a sample

Open a Trade Account

GENCLEAR F/R: Certified Safety with Superior Clarity

When safety regulations require it, don’t compromise on quality. GENCLEAR F/R is our premium Calandered Clear PVC specifically manufactured with added Fire Retardancy for your complete peace of mind.

This is the solution you need for vertical screening, outdoor blinds, and weather enclosures in commercial or public spaces where fire safety is paramount. We offer a choice of three thicknesses—0.5mm, 0.7mm, and 1.0mm—ensuring you have the right strength and stability for projects large and small.

Choose GENCLEAR F/R to meet compliance without sacrificing crystal-clear visibility.

WIDTH: 150cm
THICKNESSES: 0.5mm / 0.7mm / 1.0mm
ROLL LENGTH: 40m / 30m / 20m
NOMINAL WEIGHT: 650gsm / 900gsm / 1290gsm
SHRINK RATE: 4% Warp / 2% Weft (approx. only)
FIRE RETARDANT: AS/NZS 1530.2 / ASTM-D568
FLEXING: 200,000 cycles minimum AS-1441.6
COLD CRACK: -9°C
U/V STABILITY: 2 years minimum
FABRICATION METHODS: Hot Wedge, Hot Air or High Frequency Welding : Sewing : Adhesive

These instructions will maintain the appearance and extend the functional life of the fabric
• PVC Coated Fabrics
• Polypropylene Woven Coated Fabrics
• PVC Coated Nylon/Polyester Fabrics

PVC Coated Nylon/Polyester Fabrics
Care instructions relate to PVC coated side only of fabrics with PVC one

PROHIBITIONS/WARNINGS
• Do not use solvents, abrasives or harsh detergents to clean
• Do not dry clean
• Do not iron

GENERAL CARE INSTRUCTION
A regular wipe over with warm soapy water followed by rinsing with cold water will remove normal soiling. Where a build-up has occurred, the surface should be cleaned with a soft brush and mild, non-abrasive detergent, then rinsed thoroughly.

SPOT CLEANING/SPECIAL TREATMENTS
Mildew may be removed by wiping with a cold solution of household chlorine bleach having 4% chlorine, in the proportion of one part in four to water.
Rinse thoroughly with cold water.

The customer must inspect the goods upon delivery and report any defects, shortages, damage, or mismatches within 10 days. The company must be given a reasonable chance to inspect any allegedly defective goods. If no notice is given within the timeframe, the goods are considered accepted and free from defects. If the company agrees the goods are defective, it may choose to repair or replace them.

Returns are only accepted if the company approves them in writing, the goods are returned within 7 days at the customer’s expense, and the goods are unused, properly stored, and returned in near-new condition with original packaging and materials.

The company will not accept returns for customised goods, cut textile products, altered or tampered goods, indent goods, or goods that were improperly stored or handled by the customer.

The company may charge a handling fee of 20% of the returned goods’ value (or $100 minimum) and/or return freight costs if the return is due to the customer’s fault or omission.