AUTOTWILL 100% COTTON SEAT FABRIC

WIDTH: 150cm
ROLL LENGTH: 25m
NOMINAL WEIGHT: 460gsm
BASE FABRIC: 100% Cotton 3/1 Twill Weave
FINISH: U/V protection, rot and mildew resistant, soil release-coated
TEAR STRENGTH WARP/WEFT: 68 / 46 N (AS 2001.2.10)
TENSILE STRENGTH WARP/WEFT: 2600 / 1800 N/5cm (AS 2001.2.3)
HYDROSTATIC HEAD: 7kpa (AS2001.2.17)
CONE TEST: Less than 1ml (24 Hours)
COLOURFASTNESS: 6-7
FABRICATION METHODS: Sewing

These instructions will maintain the appearance and extend the functional life of the fabric:
• Polyester/Cotton Blend Proofed Canvas
• Polyester Proofed Canvas
• Cotton Proofed Canvas

PROHIBITIONS/WARNINGS
• Do not dry clean
• Avoid the use of soap and detergents, cleaning fluids or insecticides as they may damage the coating and promote leakage. If the canvas is machined washed, it may remove any coating or waterproofing properties from the surface. Never scrub the surface
• Do not store directly on concrete
• Do not expose to petrol, oil or solvents
• Ensure product is completely dry prior to storage

GENERAL CARE INSTRUCTION
Regular cleaning with plenty of water and a soft brush will remove most dust and dirt. Always clean from the lower edges of the fabric working upwards.
Canvas roofing should be cleaned regularly. Do not allow bird droppings, earth and or vegetable matter to remain in contact with the fabric. New canvas should be thoroughly wet before use and allowed to dry to ensure sealing up of the seams.

SPOT CLEANING/SPECIAL TREATMENTS
For the removal of mildew or more stubborn stains, use a proprietary brand of mildew remover, or mix 1 part household chlorine bleach to 4 parts water and sponge into the canvas. Allow 15 minutes contact then hose or rinse thoroughly. With age, use and repeated cleaning, there will be a loss of waterproofness. The canvas can be reproofed by using the appropriate proofing agent that is recommended for each type of canvas.

The customer must inspect the goods upon delivery and report any defects, shortages, damage, or mismatches within 10 days. The company must be given a reasonable chance to inspect any allegedly defective goods. If no notice is given within the timeframe, the goods are considered accepted and free from defects. If the company agrees the goods are defective, it may choose to repair or replace them.

Returns are only accepted if the company approves them in writing, the goods are returned within 7 days at the customer’s expense, and the goods are unused, properly stored, and returned in near-new condition with original packaging and materials.

The company will not accept returns for customised goods, cut textile products, altered or tampered goods, indent goods, or goods that were improperly stored or handled by the customer.

The company may charge a handling fee of 20% of the returned goods’ value (or $100 minimum) and/or return freight costs if the return is due to the customer’s fault or omission.