ALUMI/BLACK PE

183cm Roll Width

50m Roll Length

190 GSM

2 Year Minimum Warranty

View on trade portal

Request a sample

Open a Trade Account

ALUMI/BLACK PE is a high grade Polyethylene coated fabric.

ALUMI/BLACK PE is a two toned fabric, Black on the underside with an Aluminium Foil coating on the topside.

The Aluminium Foil offers an excellent heat refelective surface making it ideal for produce bin covers, surfboard covers or any other cover that requires the heat to be reflected away.

Because the aluminium coating is not hot air weldable there is a 30mm strip on one egde of the material with no aluminium coating to allow the joining of another sheet.

WIDTH: 180cm + 30mm weldable edge (183cm total)
ROLL LENGTH: 50m
NOMINAL WEIGHT: 190gsm
BASE FABRIC: HDPE 1000 Decitex
WEAVE: 10 x 10 per/inch
COATING: LDPE 40micron face and back
TEAR STRENGTH WARP/WEFT: 95 / 70 N
TENSILE STRENGTH WARP/WEFT: 550 / 550 N/5cm
U/V WARRANTY: 2 year minimum
FIRE RETARDANT: N/A
TEMPERATURE RANGE: -30° / +70° C
FABRICATION METHODS: Hot Wedge, Hot Air on 30mm side seam : Sewing

These instructions will maintain the appearance and extend the functional life of the fabric
• PVC Coated Fabrics
• Polypropylene Woven Coated Fabrics
• PVC Coated Nylon/Polyester Fabrics

PVC Coated Nylon/Polyester Fabrics
Care instructions relate to PVC coated side only of fabrics with PVC one

PROHIBITIONS/WARNINGS
• Do not use solvents, abrasives or harsh detergents to clean
• Do not dry clean
• Do not iron

GENERAL CARE INSTRUCTION
A regular wipe over with warm soapy water followed by rinsing with cold water will remove normal soiling. Where a build-up has occurred, the surface should be cleaned with a soft brush and mild, non-abrasive detergent, then rinsed thoroughly.

SPOT CLEANING/SPECIAL TREATMENTS
Mildew may be removed by wiping with a cold solution of household chlorine bleach having 4% chlorine, in the proportion of one part in four to water. Rinse thoroughly with cold water.

The customer must inspect the goods upon delivery and report any defects, shortages, damage, or mismatches within 10 days. The company must be given a reasonable chance to inspect any allegedly defective goods. If no notice is given within the timeframe, the goods are considered accepted and free from defects. If the company agrees the goods are defective, it may choose to repair or replace them.

Returns are only accepted if the company approves them in writing, the goods are returned within 7 days at the customer’s expense, and the goods are unused, properly stored, and returned in near-new condition with original packaging and materials.

The company will not accept returns for customised goods, cut textile products, altered or tampered goods, indent goods, or goods that were improperly stored or handled by the customer.

The company may charge a handling fee of 20% of the returned goods’ value (or $100 minimum) and/or return freight costs if the return is due to the customer’s fault or omission.