SIOEN W909011H5 MESH

WIDTH: 200cm
ROLL LENGTH: 50m
NOMINAL WEIGHT: 800gsm
BASE FABRIC: Polyester 1100 Decitex 9 x 9 H5 Dobby
COATING: PVC Dip Coated
THICKNESS: 1.5mm
TENSILE STRENGTH WARP/WEFT: 2650 / 2650 N/5cm
TEAR STRENGTH WARP/WEFT: 500 / 500 N
TENSILE STRENGTH ELONGATION: 15% warp / 15% weft
SHRINKAGE: at 200° C / 10min 3.5% warp / 3.5% weft
U/V WARRANTY: 3 year minimum
TEMPERATURE RANGE: -40° / +70° C
FABRICATION METHODS: Hot Wedge, Hot Air or High Frequency Welding : Sewing : Adhesive

These instructions will maintain the appearance and extend the functional life of the fabric
• PVC Coated Fabrics
• Polypropylene Woven Coated Fabrics
• PVC Coated Nylon/Polyester Fabrics

PVC Coated Nylon/Polyester Fabrics
Care instructions relate to PVC coated side only of fabrics with PVC one

PROHIBITIONS/WARNINGS
• Do not use solvents, abrasives or harsh detergents to clean
• Do not dry clean
• Do not iron

GENERAL CARE INSTRUCTION
A regular wipe over with warm soapy water followed by rinsing with cold water will remove normal soiling. Where a build-up has occurred, the surface should be cleaned with a soft brush and mild, non-abrasive detergent, then rinsed thoroughly.

SPOT CLEANING/SPECIAL TREATMENTS
Mildew may be removed by wiping with a cold solution of household chlorine bleach having 4% chlorine, in the proportion of one part in four to water. Rinse thoroughly with cold water.

The customer must inspect the goods upon delivery and report any defects, shortages, damage, or mismatches within 10 days. The company must be given a reasonable chance to inspect any allegedly defective goods. If no notice is given within the timeframe, the goods are considered accepted and free from defects. If the company agrees the goods are defective, it may choose to repair or replace them.

Returns are only accepted if the company approves them in writing, the goods are returned within 7 days at the customer’s expense, and the goods are unused, properly stored, and returned in near-new condition with original packaging and materials.

The company will not accept returns for customised goods, cut textile products, altered or tampered goods, indent goods, or goods that were improperly stored or handled by the customer.

The company may charge a handling fee of 20% of the returned goods’ value (or $100 minimum) and/or return freight costs if the return is due to the customer’s fault or omission.